---
title: "Opener Runs but Door Won't Move | Reno NV"
url: "https://advancedoverheadnv.com/garage-door-opener-runs-but-door-wont-move/"
canonical: "https://advancedoverheadnv.com/garage-door-opener-runs-but-door-wont-move/"
updated: "2026-11-21"
breadcrumb: "Home > Garage Door Problems > Opener Runs but the Door Won't Move"
business: "Advanced Overhead Garage Door Company"
what: "garage door repair, broken spring replacement, opener repair and new LiftMaster opener installation, new residential and commercial garage doors, and 24/7 emergency garage door service across the Greater Reno area and Northern Nevada"
phone: "775-356-0444"
phone_2: "775-883-0444"
email: "advohd@yahoo.com"
hours: "Office Mon-Sat 7:30 am-5:00 pm, Sunday closed; Emergency and same-day service available 24/7"
license: "Nevada Lic. No. 61031 (NSCB 0061031A, C-3D Overhead Doors)"
area: "Greater Reno area and Northern Nevada (service-area business)"
offer: "Free estimates"
---

# Opener Runs but the Door Won't Move

When the opener motor runs or hums and the door does not move, the cause is usually a disengaged trolley, a chain or belt off its sprocket, a worn drive gear or a broken spring that has made the door too heavy to lift. Advanced Overhead Garage Door Company repairs garage door openers of various brands and replaces broken springs in the Reno area and across Northern Nevada; call 775-356-0444.

The short answer


Safety first

If the door feels very heavy, or you heard a bang before the trouble started, do not pull the emergency release and do not run the opener again. A broken spring can let the door fall.

Call [775-356-0444](tel:7753560444)

What you may notice

- The motor hums or runs, and the light on the opener comes on
- You can hear the opener working but the carriage does not travel
- A grinding or whirring sound from the opener head
- The chain or belt hangs loose or sags
- The door will not lift by hand either, and feels very heavy

## What are the four likely causes?

The four causes below account for most doors where the opener runs but nothing moves. They are listed from the simplest to the most serious.

| Cause | What you notice | Who fixes it |
|---|---|---|
| Trolley disengaged (the emergency release was pulled or bumped) | Motor runs, carriage slides freely along the rail, door is loose | Often simple; a technician re-engages it, or see the check below |
| Chain or belt off the sprocket | Chain or belt sagging, hanging or bunched | Technician |
| Stripped drive gear or broken sprocket | Grinding or whirring, motor spins without pulling | Technician: repair the opener or replace it |
| Broken spring making the door too heavy | A bang earlier, door very heavy, a gap visible in the spring | Technician only; do not use the door |

## Why can a broken spring look like an opener problem?

The springs hold up the weight of the door, and the opener only guides it. When a spring breaks, the opener motor may start, the carriage may even move a short way, and then the opener stops or strains because it cannot lift the full weight. From the driveway it looks like the opener failed.

That is why we ask two things on the phone: did you hear a bang, and does the door feel heavy? If the answer to either is yes, the door is unsafe to operate and the repair starts at the spring. Our [garage door spring repair](https://advancedoverheadnv.com/garage-door-spring-repair/) page explains what that involves, and DASMA states plainly that spring systems are dangerous and should be repaired only by trained professionals.

## What can you safely look at?

With the door fully closed, you can look at the opener without touching the door's springs, cables or tracks.

- Stand on the floor, never on the door, and look at the carriage that rides along the rail. If it has separated from the trolley, a disengaged release is likely.
- Check the red release cord to see whether it is hanging lower than usual or has been pulled.
- Look at the chain or belt along the rail. Slack, a bunched section or a chain resting on the rail means it has come off the sprocket.
- Listen for grinding at the opener head. That points to a worn gear or sprocket.

Stop at looking. Re-engaging a trolley on a door with a broken spring, or on a door that is not closed, can be dangerous. Describe what you see when you call and we will tell you whether it is safe to try.

## What does the repair usually involve?

The CPSC's garage door sheet describes the quick release as the part that detaches the door from the opener, so a released or disengaged trolley lets the motor run without moving the door. A disengaged trolley is re-connected and the door's balance is checked. A chain or belt that has come off is put back and the tension corrected, or the part is replaced. A stripped gear or broken sprocket is repaired in many opener models, and when the opener is old or parts are no longer made, we install a new one. We are an authorized LiftMaster dealer; see [LiftMaster garage door openers](https://advancedoverheadnv.com/liftmaster-garage-door-openers/).

We send a qualified, friendly technician to give you a free estimate and have your repairs done in a few hours, depending on where you are. Our [opener repair](https://advancedoverheadnv.com/garage-door-opener-repair/) page lists what we cover, and our [won't open](https://advancedoverheadnv.com/garage-door-wont-open/) page helps if the door is also stuck.

## Opener Runs but the Door Won't Move: Questions

### Why does my opener run but not lift the door?

Either the opener is not connected to the door, a drive part inside it has failed, or the door is too heavy for it because of a broken spring. Listen for a bang earlier and feel whether the door is heavy; that decides which it is.

### Can I just re-attach the trolley myself?

Only when the door is closed and you know the springs and cables are sound. If the door feels heavy or you heard a bang, do not touch the release. Call us and describe what you see.

### Is it worth repairing an old opener?

Often yes, if the fault is a gear, a sprocket, a chain or a circuit board. When parts are hard to find or the opener has failed repeatedly, a new opener is the better value. We give you a free estimate and tell you which we would choose.

### Do you repair openers of different brands?

Yes. We have over 14 years of experience working on various brands of garage doors and openers, and we are an authorized LiftMaster dealer for new openers.

[More questions and answers](https://advancedoverheadnv.com/faq/)

### Sources (2)

- DASMA (Door & Access Systems Manufacturers Association) : [dasma.com/safety-tips/](https://www.dasma.com/safety-tips/) (checked November 2026)
- U.S. Consumer Product Safety Commission : [cpsc.gov/s3fs-public/garage.pdf](https://www.cpsc.gov/s3fs-public/garage.pdf) (checked November 2026)
